It is one of the most common modes of transportation, carrying many times the world’s population every month. It is also a very safe way to travel. There is a much better chance of winning the large Euro-Millions prize than of being injured in getting from point A to point B.
For those who cannot guess, all of this is true for lifts (elevators in American English).
Everyone in the industry should be proud of that performance. At the same time, even better performance is possible.
In that spirit, a new standard, EN81-20/50, was published in July 2014. It replaces the old standard, EN 81-1/2+A3, which has been around since 2000. After September 1st 2017, EN81-20/50 will become the only standard in Europe. Until then, both are in force.
Besides safety enhancement, part of the reason for the new standard is that elevators are evolving. At one time, hydraulic or asynchronous motors stored in a machine room were commonly used to power an elevator. Now, more and more compact synchronous motors can be found directly stored in the elevator shaft, providing the power needed for motion from there. This shift in motor location and type has implications for electric devices, embedded variable speed drives and communication.
For contactors and circuit breakers, there are four requirements mandated by the new standard.
1. The first is that components have to follow type 1 coordination in accordance with EN 60947-4-1:2010, 126.96.36.199. This means, any short circuit downstream of the circuit breaker/contactor combination must present no risk for the operator and the installation. However, restarting may require servicing via repair or replacement of the contactor.
2. The new standard calls for an 90%AC-3 / 10%AC-4 Utilization Category mix for the main contactors directly controlling elevator motors. Contactors shall be selected accordingly with motor’s usage, keeping in mind that when a motor starts, a current surge is observed.
So, what does that mean?
a) If the motor starts and runs for a sufficient period of time (e.g. >1 min) when it is stopped, the current to be broken is the nominal current. In this case, the contactor has to be chosen relatively to AC3 utilization category
b) If the motor is used in an inching/jogging manner, the broken current may often be the inrush current, which is more constraining than the nominal current to break. In that case, the contactor must be selected according to AC4 utilization category
c )EN81-20 requires main contactors directly controlling elevator motors to be selected so as to be able to support 90% of AC3 and 10% of AC4 maneuvers. This will ensure an adapted lifetime of the contactor respectively to its use
3. Mirror contacts are compulsory. As specified in EN 60947-4-1:2020 Annex F, a mirror contact is a normally closed auxiliary contact, linked with the main contacts of a contactor such that auxiliary and power contacts can’t be closed simultaneously. Mirror contacts enhance safety, ensuring that contactor’s state is properly transmitted in safety chains.
4. Mechanically linked auxiliary contacts are required for contactors. It ensures that a Normally Opened (NO) and a Normally Closed (NC) auxiliary contact cannot be simultaneously closed or opened. This prevents, again, safety chain errors.
Designing and constructing a modern elevator is a challenge. Ease of use, cost and safety all are important. The new standard can help meet those goals and Schneider Electric is there to provide help and expertise.
For instance, in Schneider Electric’s TeSys D motor starter range, auxiliary contacts and contact blocks are intrinsically compliant with the new standard. They allow monitoring of the state of contactors and can be incorporated into a safety chain, highlighted thanks to a safety red cover accessory.
Specific AC3/AC4 contactor selection with type 1 coordination have also been calculated and are available in our dedicated Control panel Technical guide: How to choose the contactors for elevator machinery.
Besides motor starter selection, this guide contains other useful information such as brake contactor selection, relay and contactors’ recommendations, other Schneider Electric components for elevators.